Speakman SEF-1850-TW Installationsanleitung PDF herunterladen

SEF-1850

SEF-1850-8

Start off by following steps 1 through 3 of the SEF-1850 installation

instructions. Next, prepare the SE-370 for mouniting. After applying Teflon

tape to the larger 1/2” threads, screw the adapters into the 3 ports of the

SE-370. Wrench tighten. Refer to the rough in diagram on the last page

during installation.

The SE-370 can now be mounted to the wall. The unit should be fastened

to the wall using 1/2” pipe hangers with wall plates (not included), no

more than 18” below the countertop. Be sure to mount the SE-370 in a

location that will not interfere with the drain assembly or wall stops.

Crescent

Wrench

Flat Head

Screwdriver

Keep the EYESAVER

faucet looking new by cleaning

it periodically with a soft cloth. Avoid abrasive

cleaners, steel wool, and harsh chemicals as these

will dull the finish and void your warranty.

Cover your drain to prevent loss of parts. Always

wear eye protection.

The supply line for the eyewash shall provide an

uninterruptible supply of flushing fluid at a minimum

of 30 psi flowing pressure. If shut off valves are

installed in the supply line of the eyewash, provisions

shall be made to prevent unauthorized shut off.

ANSI Z358.1 requires that all emergency equipment

shall be tested weekly to verify proper operation and

inspected annually to assure conformance with

ANSI Z358.1 requirements. Be sure to read

instructions thoroughly before beginning installation.

Do not overtighten any connections or damage may

occur.

92-SEF-1850-TW-R1

Instructions for Adding

Tepid Water Eyewash

Option to Models:

Teflon

Tape

1 2 3

Inhaltsverzeichnis

Seite 1 - SEF-1850-8

SEF-1850SEF-1850-8Start off by following steps 1 through 3 of the SEF-1850 installation instructions. Next, prepare the SE-370 for mouniting. After ap

Seite 2

Retrieve the two 6” long stainless steel hoses from the box. Connect one to the COLD supply valve, and the other to the HOT supplyvalve. Wrench tighte

Seite 3 - SE-1850-TW ROUGH-IN DIAGRAM

Connect the red (HOT) hose from the SEF-1850 to the “F” port on the HOT supply tee. Repeat this process for the blue (COLD) hosecoming from the SEF-1

Kommentare zu diesen Handbüchern

Keine Kommentare

Speakman SEF-1850-TW Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Sanitärkeramik Speakman SEF-1850-TW herunter. Speakman SEF-1850-TW Installation Guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sanitärkeramik Speakman SEF-1850-TW